Chapter 25 Alarm threshold of the Heading erroneous
Heading erroneous function is monitored the rate of turn between the Gyrocompass and Aux. port
sensor , In case of the heading sensor is connected to the Aux. port.
①
Set the detection of the rate of turn
②
Set the detection time
１．
Select the item
（１）
Press the
ENTER
ENTERENTER
ENTER
key after displayed "
Option Set 6
…
"(PT500A)"
or
"
Option Set 7
…
"(PT500D
･
SUBAUTO) on the data display.
Data display become under setting mode.
（２）
Change the setting item by using the
△
△△
△
+
++
+
or
▽
▽▽
▽
-
--
-
Key
①⇔②⇔③⇔④⇔①
①
③
②
Press
ENTER
ENTERENTER
ENTER
key to set the setting item..
２．
Set the detection of the rate of turn
（１）
Press the
ENTER
ENTERENTER
ENTER
key after displayed "
Check RoT= ##†s
" on the data display.
Data display become under setting mode.
Setting range: from 0 to 20
(Initial value is set 0 deg./sec)
If you set the 0 , it means to cancel the monitor of heading erroneous.
（２）
Press
△
△△
△
+
++
+
or
▽
▽▽
▽
-
--
-
key to select the detection value of the rate of turn .
Press
ENTER
ENTERENTER
ENTER
key to set the detection value.
To Next Page
Loading...