YOKOGAWA PT500 User Manual

2-37
SM80B22M02E
３．５．１ Set the existing LOG input format
（１） Set the
mode. Then press the ENTER
ENTERENTER
ENTER key.
Display the current existing format on the data display.
（２）Press the △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- key to select the existing LOG format.
（３）In case of you change the existing LOG input data. Back to (1) item, Then press the ENTER
ENTERENTER
ENTER key.
The data display becomes under setting mode
The part of a….a is displayed setting condition.
Refer to the contents to next page.
（４）Press the △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- key. After the display, of the existing format.
After selected the setting mode, press the ENTER
ENTERENTER
ENTER key.
MAINTENANCE 1
…
I/F SET-UP
I/F SET
-
UP
…
SOFTWARE SET
I/F SOFT SET
-
UP
…
PORT= LOG
LOG SOFT
…
FORMAT = aaaaa
LOG SOFT
…
FORMAT < EXIST
LOG EXIST
…
=NMEA xxVBW (W)
LOG
EXIST
…
=NMEA xxVBW (W)
LOG
EXIST
…
= [PREV]
LOG
EXIST
…
= [TOP]
LOG EXIST
<aaaaaaaaaaaaaaa

YOKOGAWA PT500 Specifications

General

Brand	YOKOGAWA
Model	PT500
Category	Autopilot System
Language	English