YOKOGAWA PT500 - Setting of the Reception Header

2-19
SM80B22M02E
3.1.2.2 Setting of the reception header
Set the reception header
The Header consists of five character from ＄ to reception discrimination data.
（１） When you are displayed "ADDRESS = $aaaaa" on the data display ,then press ENTER
ENTERENTER
ENTER key.
The data display become under setting mode.
←Cursor position is inputting point
（２）Press △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- key to set the cursor point. Then change the data by turning the Set
course dial. Turn to the clockwise direction , data is increased and turn to the counter
clockwise direction ,data is decreased. (Data is A to Z alphabet)
（３）After input the header , then press ENTER
ENTERENTER
ENTER key.
ADJUST
ENTER
ENTER
ENTER
ADJUST
ENTER
ENTER
ENTER
GYRO NEW
ADDRESS < $AAAAA
GYRO NEW
ADDRESS < $GPABC
ADJUST MODE
99…
MAINTENANCE MODE
MAINTENANCE 1
…
I/F SET-UP
ADJUST MODE
1
…
DIMMER/CONTRAST
SPD AUTO 13.5 Kt
HEADING-G 235.8ˆ
GYRO NEW
…
ADDRESS = $aaaaa
GYRO SOFT
…
FORMAT = NEW
I/F SOFT SET
-
UP
…
PORT = GYRO
I/F SET
-
UP
…
SOFTWARE SET
I/F SET
-
UP
…
HARDWARE SET
GYRO NEW
…
ADDRESS < $AAAAA
GYRO NEW
…
ADDRESS < $AAAAA
GYRO NEW
…
ADDRESS < $AAAAA
GYRO NEW
…
ADDRESS < $AAAAA
GYRO NEW
…
ADDRESS < $AAAAA