YOSHIDA XP73 - Page 123

User Program Mode
121
Operation Manual
Descriptions of User Program Mode
Program No. Description Setting Default
Prog No.02
Specieswhetheran
audible alarm sounds
when any button is
pressed on the touch
panel.
Audible alarm
On
On: an alarm sounds Off: no alarm sounds
Prog No.03
Specieswhether
the arm automatically
moves to the patient
positioning point after
image acquisition.
Patient positioning point (after acquisition)
On
On:specied Off:notspecied
Prog No.04
Speciespower-on
behavior
Power-on behavior
Entr
Off: no auto
behavior
Entr: patient
positioning
point
Rest: auto reset
point
Prog No.05
Speciesthe
correction level of
cervical spine for
image acquisition
Cervical spine correction
Lo
Off: no correction Hi: step 2 Lo: step 1
Prog No.06
Specieswhethera
service maintenance
message appears
once 2,000 th
exposure has
nished.
Service maintenance message
No
Yes: no message appears No: message appears
Prog No.07
Resets the settings
in memory to their
defaults.
User program settings
No
Yes: resets to defaults No: existing settings retained
Prog No.09
Stores the initial state
in memory at power-
on.
Initialization at power-on
No
Yes: Initialization at power-on No: not stored in memory
Prog No.11
Specieswhetheran
audible alarm sounds
when an error occurs.
Audible alarm sound
On
On: an alarm sounds Off: no alarm sounds
Prog No.22*
Sets the irradiation
conditions of the
AUTO mode in 3D
image acquisition.
Irradiation conditions in 3D exposure.
2
1:82kV,2.0mA 2:82kV,4.0mA 3:82kV,6.3mA
* For equipment with 3D function
Suppl. : During setting the mode in the User Program Mode, any operation from the
exposure switch or control panel is inactivated.