YOSHIDA XP73 - Before Using this Product

17
Operation Manual
Precautions for Installation and Relocation
1. Installation Areas
(1) Install in the X-ray room.
(2) The size of the installation area should be at least 1,350 mm (W) × 1,350 mm (D) ×
2,400 mm (H) or 54" (W) × 54" (D) × 95" (H) (* in case of Cephalometric -attached
model, 2,300 mm (W) × 1,500 mm (D) × 2,400 mm (H) or 92" (W) × 60" (D) × 95"
(H)), to allow the patients to be put in and taken out, the equipment to be operated,
the equipment to be used correctly such as allowing for daily inspections, and to
perform work to maintain equipment performance.
If installed alongside other pieces of equipment, be sure not to place them within the
range of the arm unit’s movement.
The installation area size differs depending on the room shape, door locations, etc.
For details contact the dealer where the equipment was purchased.
(3) Rapidly warming a cool X-ray room results in condensation inside the equipment that
causes problems. When heating a room, do so slowly.
The environmental range for using this equipment in good condition is as follows.
Temperature: 10 to 40ºC (50 to 95°F)
Relative humidity: 30 to 75% (no condensation)
Air pressure: 700 to 1060 hPa
(4) Installintheareaequippedwithlightxturetoensuretheproduct’soperability,X-ray
image quality and its viewability. Set the monitor to the area where is unaffected by
thelightreectionfromindoorsandoutdoors.
2. Power
(1) Prepare a hospital grade outlet (grounding is required) of your area’s power voltage
and dedicate it for X-era Smart
 100V:MorethanAC100V,15.0A
 110V:MorethanAC110V,18.1A
 120V:MorethanAC120V,16.6A
 220V:MorethanAC220V,9.09A
 230V:MorethanAC230V,8.69A
 240V:MorethanAC240V,8.33A
(2) Never use an extension cord or plug multiple cords into one outlet.
(3) Wipe off dust that has accumulated on the power plug and outlet. Leaving the dust
onthemcouldallowaminuteelectricalcurrenttoowduetohumidity,etc.,and
resultinoverheatingorare.
(4) Do not impair, damage, or modify the power cord. In addition, do not place heavy
objects on it, pull on it, or bend it excessively as these could damage the power cord
andcauseareorelectricalshock.
(5) Be sure to connect the additional protective groundings of the main unit and the
computer.