Maintenance Services
127
Operation Manual
7 Maintenance Services
X-era Smart has been designed so that the user may take full use of it reliably and
satisfactorily over many years. To assure the operator’s and the patient’s safety in using the
equipment, the user is responsible for performing preventive maintenance services.
To perform the preventive maintenance services, follow the instructions in Section "7.2
Periodical Checks" and "7.3 Periodical Check Services". If you desire to outsource the
regular checks, feel free to contact your dealer. It should be noted that if you outsource these
check services, they are not always performed just as described in the regular check list.
* Caution
• To assure the operator’s and the patient’s safety in using the equipment, be sure to read
through this section.
7.1 Cleaning
1. Cleaning coated surfaces
Wipe out dirt on the coated surfaces of the equipment with a water-dampened soft cloth
and then wipe away remaining moisture with a dry cloth.
2. Cleaning plated surfaces
Wipe out dirt on the plated surfaces of the equipment with a water-dampened soft cloth
and then wipe away remaining moisture with a dry cloth.
3. Cleaning exterior cover surfaces
Wipe out dirt on the cover surfaces with a mild detergent-dampened, well-wrung soft
cloth, and then wipe away remaining moisture with a dry cloth.
4. Cleaning the chin rest block and adaptor
Wipe out dirt on the chin rest and adaptors for edentulous jaw and TMJ with a mild
detergent-dampened, well-wrung soft cloth, and then wipe away remaining moisture with
a dry cloth.
5. Cleaning the head support
Remove the head and temporal head supports by pulling directly downward from the
head support unit. Wipe off dirt (e.g. hair dressing) on the head and temporal head sup-
port with a mild detergent-dampened, well-wrung soft cloth, and then wipe away remain-
ing moisture with a dry cloth.
6. Cleaning the PC
Refer to the Instruction Manual provided with your PC to follow the appropriate cleaning
procedure.
To Next Page
Loading...