Directions for Use
70
Operation Manual
Adjusting the head support
Slide the head support in contact with
the patient’s head while gripping its
base and then close it. With the Auto
setting, the tube voltage appropriate for
the patient will be automatically set.
At the end of adjustment, try to turn on
the positioning beams to check that
they focus on their correct positions.
* Caution
• Do not open or close the head forcedly without gripping its base. Otherwise, the patient
may be injured.
Turning off the positioning beams
Press the Beam switch to turn off the positioning beam. Return the positioning mirror to its
original position.
* Caution
• Oncepositioninghasbeensuccessfullynished,besuretoreturnthepositioningmirror
to its original position.
To Next Page
Loading...