Zebra DS8178

User Preferences 5 - 3
Night Mode Trigger (DS8178-HC Only) 1215 F8h 04h BFh Disable 5-13
Night Mode Toggle (DS8178-HC Only) N/A N/A N/A 5-13
Lamp Mode Control 1711 F8h 06h AFh Disable 5-14
Lamp Mode Timeout 1712 F8h 06h B0h 5 Minutes 5-15
Low Power Mode 128 80h Enable 5-16
Time Delay to Low Power Mode 146 92h 5 sec 5-17
Timeout to Low Power Mode from Auto Aim 729 F1h D9h 15 sec 5-19
Hand-Held Trigger Mode 138 8Ah Level 5-20
Hands-Free Mode 630 F1h 76h Enable 5-21
Hand-Held Decode Aiming Pattern 306 F0h 32h Enable 5-22
Hands-Free (Presentation) Decode Aiming
Pattern
590 F1h 4Eh Disable Hands-Free
Decode Aiming Pattern
5-23
Picklist Mode 402 F0h 92h Disabled Always 5-24
FIPS Mode 736 F1h E0h Disable 5-25
Continuous Bar Code Read 649 F1h 89h Disable 5-25
Unique Bar Code Reporting 723 F1h D3h Enable 5-26
Decode Session Timeout 136 88h 9.9 sec 5-26
Hands-Free Decode Session Timeout 400 F0h 90h 15 5-27
Timeout Between Decodes, Same Symbol 137 89h 0.5 sec 5-28
Timeout Between Decodes, Different
Symbols
144 90h 0.1 sec 5-28
Triggered Timeout, Same Symbol 724 F1 D4 Disable 5-29
Decode Mirror Images (Data Matrix Only) 537 F1h 19h Auto 5-30
Mobile Phone/Display Mode 716 F1h CCh Normal 5-31
PDF Prioritization 719 F1h CFh Disable 5-32
PDF Prioritization Timeout 720 F1h D0h 200 ms 5-32
Presentation Mode Field of View 609 F1h 61h Full 5-33
Decoding Illumination 298 F0h 2Ah Enable 5-34
Motion Tolerance (Hand-Held Trigger Mode
Only)
858 F2h 5Ah Less Motion Tolerance 5-34
Table 5-1 User Preferences Parameter Defaults (Continued)
Parameter
Parameter
Number
1
SSI Number
2
Default
Page
Number
1
Parameter number decimal values are used for programming via RSM commands.
2
SSI number hex values are used for programming via SSI commands.