Zebra DS8178

SSI Interface 8 - 21
Event Reporting
The host can request the digital scanner to provide certain information (events) relative to the digital scanner
behavior. Enable or disable the events listed in Table 8-4 and on the following pages by scanning the appropriate
bar codes.
Decode Event
Parameter # 256 (SSI # F0h 00h)
When enabled, the digital scanner generates a message to the host upon a successful bar code decode. When
disabled, no notification is sent.
Table 8-4 Event Codes
Event Class Event Code Reported
Decode Event Non parameter decode 0x01
Boot Up Event System power-up 0x03
Parameter Event Parameter entry error
Parameter stored
Defaults set (and parameter event is
enabled by default)
Number expected
0x07
0x08
0x0A
0x0F
Enable Decode Event
(1)
*Disable Decode Event
(0)