Radio Communications 4 - 25
Beep on Insertion
Parameter # 288 (SSI # 20h)
When a digital scanner is inserted into a cradle and detects power, it emits a short low beep. This feature is
enabled by default.
To enable or disable beeping on insertion, scan the appropriate bar code below.
Beep on <BEL>
Parameter # 150 (SSI # 96h)
When this parameter is enabled, the scanner issues a beep when a <BEL> character is detected on the serial line.
<BEL> is issued to gain a user's attention to an illegal entry or other important events.
*Enable Beep on Insertion
(1)
Disable Beep on Insertion
(0)
NOTE This parameter only applies to SPP (Serial Port Profile). The RS-232 interface on the cradle has this
feature when Beep on <BEL> is enabled.
*Beep on <BEL> Enable
Beep on <BEL> Disable
To Next Page
Loading...