Zebra DS8178

RS-232 Interface 9 - 3
RS-232 Parameter Defaults
Table 9-1 lists the defaults for RS-232 host parameters. To change any option, scan the appropriate bar code(s)
provided in the RS-232 Host Parameters section beginning on page 9-4.
NOTE See Appendix A, Standard Parameter Defaults for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 9-1 RS-232 Host Default Table
Parameter Default
Page
Number
RS-232 Host Parameters
RS-232 Host Types Standard 9-6
Baud Rate 9600 9-8
Parity Type None 9-9
Stop Bits 1 Stop Bit 9-10
Data Bits 8-Bit 9-10
Check Receive Errors Enable 9-11
Hardware Handshaking None 9-11
Software Handshaking None 9-13
Host Serial Response Time-out 2 sec 9-15
RTS Line State Low RTS 9-16
Beep on <BEL> Disable 9-16
Intercharacter Delay 0 msec 9-17
Nixdorf Beep/LED Options Normal Operation 9-18
Ignore Unknown Characters Send Bar Code 9-18
Note: The DS8178 supports one stop bit only.