Zebra DS8178

User Preferences 5 - 29
Triggered Timeout, Same Symbol
Parameter # 724 (SSI # F1 D4)
Scan Enable Triggered Timeout, Same Symbol below to apply Timeout Between Decodes, Same Symbol
(parameter #137 on page 5-28) in hand-held trigger mode. Subsequent scans of Enable Triggered Timeout,
Same Symbol are ignored until Timeout Between Decodes, Same Symbol expires.
NOTES 1. This feature does not apply to Timeout Between Decodes, Different Symbols.
2. Timeout Between Decodes, Same Symbol should not be greater than or equal to the Time Delay
to Low Power Mode (parameter #146 on page
5-17).
Enable Triggered Timeout, Same Symbol
* Disable Triggered Timeout, Same Symbol