RS-232 Interface 9 - 9
Parity
A parity check bit is the most significant bit of each ASCII coded character. Select the parity type according to host
device requirements.
•
Select Odd parity to set the parity bit value to 0 or 1, based on data, to ensure that the coded character
contains an odd number of 1 bits.
•
Select Even parity to set the parity bit value is set to 0 or 1, based on data, to ensure that the coded
character contains an even number of 1 bits.
•
Select None when no parity bit is required.
NOTE Parity of None is not valid when Data Bits is set to 7-bit.
Odd
Even
* None
To Next Page
Loading...