Zebra Silverline ZT410 - Page 196

Index
196
P1089083-001 ZT410 RFID Printer for Silverline Media User Guide 10/7/16
print quality
bar code does not scan, 144
darkness comparison during FEED self test, 159
printhead pressure adjustment, 126
troubleshooting, 142
print server
active print server user menu item, 97
characteristics of wired connection, 185
characteristics of wireless connection, 186
default gateways, 100
ESSID, 102
IP addresses, 98
IP protocol, 101
MAC address, 102
network configuration label, 84
primary print server user menu item, 97
reset network settings, 103
signal, 103
print speed, 77
PRINT STATION menu item, 96
Print Touch feature, 178
print width adjustment, 80
printer configuration label, 84
printer diagnostics, 156
printer driver, 24
printer locks up, 154
printer parameters, 19
printer settings
darkness, 77
label left position, 81
maximum label length, 83
media type, 78
print method, 78
print mode, 81
print speed, 77
print width, 80
reprint mode, 82
settings not taking effect, 154
tear-off position, 79
printhead
adjust printhead pressure, 126
HEAD COLD message
cycling with other messages, 151
displaying alone, 152
how to clean, 136
PH NOT AUTHENTICATED message, 151
PRINT HEAD OVERTEMP message, 151
THERMISTOR PREPLACE PRINTHEAD
message, 151
printing specifications, 182
programming position, 107
Q
QR codes with error messages, 149
QuickHelp pages, 149
R
radiation exposure limits, 4
read power, 108
read/write position, 107
recycling printer parts, 138
reflective sensor selection, 114
registration loss during printing, 142
reinitialize printer server, 90
relative humidity
operating, 23
operating and storage, 184
reload last saved settings, 90
replacement parts, 138
report shipping damage, 22
reprint mode, 82
reset network settings, 103
reset printer to default values, 90
reset to defaults, 90
RFID
antenna element, 108
country code, 104
programming position, 107
read power, 108
read RFID data, 105
RFID test, 106
specifications, 182
status, 104
tag calibration, 104
troubleshooting, 146
valid and void label counters, 109
write power, 109
ribbon
broken or melted ribbon, 145
loading, 68
removal, 130
ribbon not detected correctly, 145
setting Thermal Transfer mode, 78
wrinkled ribbon, 145
RIBBON IN message, 150
RIBBON OUT message, 150
ribbon sensor calibration
procedure, 121
ways to initiate, 91
ribbon specifications, 183
roll media described, 20
routine cleaning schedule, 134
run a ZBI program, 93