Zebra Z4Mplus User Manual

72 Z4Mplus and Z6Mplus User Guide
Configuration
Configuration and Calibration Sequence
DATA BITS Setting Data Bits: Press the INCREMENT (+) or
DECREMENT (–) key to display other choices.
Default: 7-bits
Selections: 7-bits, 8-bits
The data bits of the printer must match the data bits of the
host computer for accurate communications to take place.
Set the data bits to match the setting being used by the host
computer.
Note • Must be set to 8 data bits to use Code Page 850.
PARITY Press SELECT to make change.
Setting Parity: Press PLUS (+) or MINUS (–) to display
other choices.
Default: None
Selections: None, even, odd
Press SELECT to accept the change.
The parity of the printer must match the parity of the host
computer for accurate communications to take place. Select
the parity that matches the one being used by the host
computer.
HOST HANDSHAKE Press SELECT to make change.
Setting Host Handshake: Press PLUS (+) or MINUS (–) to
display other choices.
Default: XON/XOFF
Selections: XON/XOFF, DTR/DSR, RTS/CTS
Press SELECT to accept the change.
The handshake protocol of the printer must match the
handshake protocol of the host computer for
communications to take place. Select the handshake protocol
that matches the one being used by the host computer.
Display Shows Action/Explanation

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing