84 Z4Mplus and Z6Mplus User Guide
Configuration
Configuration and Calibration Sequence
SAVE SETTINGS
Save Settings: Press PLUS (+) or MINUS (–) to display
other choices.
Default: Permanent
Selections: Permanent, temporary, cancel, load defaults,
load last save
Press SELECT to accept the change.
This display appears when you attempt to exit the
configuration mode.
Permanent: Permanently saves the changes, even when
printer power is turned off.
Temporary: Saves the changes until you change the values
again or until power is turned off.
Cancel: Cancels all changes from the time you entered the
configuration mode except for darkness and tear-off position
(if they were changed).
Load defaults: Loads factory defaults.
Load last save: Loads the values from the last permanent
save.
PRINTER READY
Press SETUP/EXIT to activate the displayed choice.
You have exited the configuration and calibration sequence
and are now ready for normal printer operation.
Display Shows Action/Explanation
To Next Page
Loading...
