Zebra Z4Mplus User Manual

Configuration
Configuration and Calibration Sequence
Z4Mplus and Z6Mplus User Guide 83
LANGUAGE Press SELECT to make change.
Selecting the Display Language: Press PLUS (+) or
MINUS (–) to display other choices.
Default: English
Selections: English, Spanish, French, German, Italian,
Norwegian, Portuguese, Swedish, Danish, Spanish 2, Dutch,
Finnish, Japanese
Press SELECT to accept the change.
This parameter allows you to change the language used on
the front panel display.
You have now completed the entire configuration and calibration sequence. You may
either press SELECT or SETUP/EXIT.
DARKNESS You are now back at the first parameter in the configuration
sequence.
If you pressed SELECT but are through programming the
printer configuration, you may press SETUP/EXIT and
continue with the SAVE SETTINGS function.
Display Shows Action/Explanation

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing