Zebra ZXP 1 Series User Manual

130 Zebra ZXP Series 1 Card Printer Service Manual P1061942-001
5: Replacement Procedures
Procedures
Parameter Update
Step 1. Go to Start > Devices and Printers. Right click on the Zebra ZXP Card Printer
listing, then select Printer properties.
Step 2. Click on Device Settings > Tools.
Step 3. This brings up the Tools dialog box.
Important • Before starting the Firmware Update, refer to the Standard Test Card you
printed prior to removing and replacing the Main
PCBA. You will need the Head Resistance,
the X and Y Offsets, and the End of Text value to update the firmware on the replacement
Main
PCBA.
If for any reason you were unable to print the Test Card, contact Zebra Technical Support to
obtain the above values.
Type the
command
here ...
... then
click the
Execute
button.

Zebra ZXP 1 Series Specifications

General

Resolution	300 dpi
Connectivity	USB 2.0
Power Requirements	100-240 VAC, 50-60 Hz
Print Technology	Dye sublimation
Card Capacity	100 cards (input hopper)
Card Size	CR-80 ISO 7810
Dimensions	368 mm (D)
Memory	32 MB
Operating Temperature	15°C to 30°C
Operating Humidity	20% to 65% non-condensing
Card Thickness	0.3mm - 1.06mm