54 Zebra ZXP Series 1 Card Printer Service Manual P1061942-001
2: Installation and Setup
Changing the Printer Driver Options
- Copies - Sets the number of copies of cards printed.
- Printing Mode - Sets the type of printing required:
• Print.
• Encode Only is used when magnetic encoding is the only function desired,
printing will not occur.
• Print and Encode on same side prints on the magnetic stripe side of the card.
• Single Feed options (refer to Appendix D for details on the single-card feed mode)
- Card feeder: The printer will attempt to a pull a card from the Card Feeder. If the
Card Feeder is empty, the printer will generate an
OUT OF CARDS error message.
- Single feeder slot: For each print job, the printer will generate an
INSERT CARD
message. Any cards in the Card Feeder will not be used.
- Auto feed: If a card s inserted in the single feed slot, the printer will use that card;
otherwise it will pull a card from the Card Feeder. If the Card Feeder is empty, the
printer will generate an
OUT OF CARDS error message.
• Ribbon info and options
- Ribbon type displays type of ribbon installed in printer.
Depending on the printer model and ribbon combination selected, the Black Panel
Options and Overlay Varnish Options buttons are enabled for color ribbons and
disabled for monochrome ribbons; see Page 55 and Page 61 respectively.
Ribbon Description
Eco Cartridge
Image Count
YMCKO
100
1/2 YMCKO
400
Black Monochrome
1000
White Monochrome
500
To Next Page
Loading...
Need help?
General
