P1036102-007 ZXP Series 7 Card Printer Service Manual 85
Replacement Procedures for the Printer
Procedures: Print Engine
Printhead Housing Assembly
Printhead Housing
Step 1. Remove the Printhead Assembly from the Printhead Housing Assembly
(page 81).
Step 2. Pull the Printhead Power and Data Cable out of the Printhead Housing.
Step 3. Unplug the ribbon sensor cable-to-cable connection.
Step 4. Set the Printhead Housing Assembly aside.
Printhead Latch Assembly
Step 1. When the slot is in the vertical position, the Printhead Latch is locked.
To Next Page
Loading...
