OPERATION
Axio Imager Operating the motorized microscope via the touchscreen of the TFT display Carl Zeiss
M70-2-0020 e 06/2009 430000-7344-001 121
− The DIC slider employed can be chosen in the
following pop-up menu. If a motorized
condenser is utilized, the condenser disk will
automatically move to the correct condenser
position as the contrast method is selected.
− Via Cat. No. button
The user must enter the Zeiss reference number
(XXXXXX-XXXX-XXX) to select an objective.
To execute the configuration procedure, press
the Save button. To abort the procedure, press
the Cancel button.
When entering the 15-digit Zeiss
Catalogue No., the leading six zeros or
the following seven zeros (after
123456 enter a hyphen (-) or enter
1234-567 and press OK). The missing
zeros will be added automatically.
Whenever a nosepiece and objectives with automatic component detection have been selected as stand
equipment, the configuration of objectives may be triggered by pressing the Automatic detection
button. The user does not have to perform any manual settings then.
Manually edited objective positions will not be overwritten by Automatic Component Detection.
They must be entered manually as empty positions beforehand.
Once a new objective has been allocated, the relevant objective button on the Microscope
turrets page will show the magnification and immersion data of that objective.
Fig. 4-59 Allocating the DIC slider
Fig. 4-60 Configuring the objective via
reference number
To Next Page
Loading...
