OPERATION
Axio Imager Operating the motorized microscope via the touchscreen of the TFT display Carl Zeiss
M70-2-0020 e 06/2009 430000-7344-001 127
(4) Stage tab
If a motorized microscope stage (equipped with a
CAN bus controller) is used, this tab will be
displayed. Once an objective has been configured,
the stage is assigned a defined travel speed for the
objective position concerned.
Pressing one of the position buttons allows the
travel speed of the motorized stage to be adapted
separately to the objective magnification
concerned via the ◄► buttons.
With the Stage in load position function, the
user can activate or deactivate the XY stage
movement for the load position / operating
position. This has an effect on the functionality of
the Load position button available on the
Microscope operation page.
When the function is activated, the focusing drive
will first move into the load position, with the
stage subsequently traveling forward toward the
user. As a result, the specimen can be easily
changed.
(5) Camera ports tab
This tab allows you to configure the adapters and
beam splitters (beam-splitting mirrors / reflecting
mirrors) for the camera ports (Top Port / Back Port /
Deflection Plane).
Before attaching/removing the camera
path deflection, left (Deflection Plane)
or before any tube change, switch off
the microscope to ensure that the
system detects the correct port status
during the next initialization process.
Fig. 4-71 Mikroscope -> Settings ->
Components -> Stage
Fig. 4-72 Setting the stage speed
Fig. 4-73 Microscope -> Settings ->
Components -> Camera ports
To Next Page
Loading...
