Zeiss Axio Imager - Page 128

OPERATION
Carl Zeiss Operating the motorized microscope via the touchscreen of the TFT display Axio Imager
128 430000-7344-001 M70-2-0020 e 06/2009
Adapter
Up to three buttons are displayed here dependent
on the equipment of the camera path deflection
and the tube used. The status of the ports is
detected by the system during initialization (and on
activation of the Settings/Components page).
• To assign an adapter to a button, press the gray
button.
This will bring up the Select Camera Adapter
list (
Fig. 4-74).
• Choose the installed adapter from the list using
the ▲ ▼ buttons.
• Press the Save button, to assign the selected
adapter to the port. Press the Cancel button to
close the window without any selection.
The button is now labeled with the magnification
factor. Proceed analogously for the other ports.
Splitter
Up to three buttons are displayed here dependent
on the equipment of the camera path deflection
and the tube used. The status of the ports is
detected by the system during initialization (and on
activation of the Settings/Components page).
• To select a splitting ratio, press the gray button.
This will bring up the Select Splitting Ratio
list.
• Press the buttons for the desired splitting ratio;
multiple selections are possible.
• Press the Save button, to store the selected
splitting ratio. Press the Cancel button to close
the window without any selection.
The button is now labeled with the splitting ratio.
Proceed analogously for the other ports.
The configured splitting ratios will be
offered then for selection on the Light
Path tab of the Microscope/
Operation page.
Fig. 4-74 Selecting the camera adapter
Fig. 4-75 Selecting the splitting ratio