INTRODUCTION
Page 1
1.0 INTRODUCTION
1.1 THIS MANUAL
The purpose of the ClearCommand System manual is:
• Operation
(Section 2.0)
• Installation (Section 5.0)
• Set-up Procedure (Section 6.0)
• Adjustments (Section 7.0 and 8.0)
• Trouble Shooting Reference (Appendix B)
Keep this Manual on the vessel for future reference.
Throughout the manual special attention should be paid to the fol-
lowing boxes:
Appendix A contains the Service Sheets created by ZF Mathers to
aid in servicing, set-up, warranty, and documenting of this vessels
parameters.
Appendix B contains a brief Trouble Shooting. If you cannot find a
solution within the Trouble Shooting, contact ZF Mathers Service
Department.
Appendix C contains the System Drawing and Bills of Material.
During Installation and Testing, take special care to verify all wiring
is to specifications, terminations are correct, and that all Notes in the
System Drawing are followed.
NOTE: Contains Helpful Information
CAUTION: Damage to equipment may result if the Caution is ignored.
WARNING: Injury may result if the Warning is ignored.
To Next Page
Loading...
Need help?
General
