ZSK JAFA - Tubular System to Cap Embroidery; Post Mode Change Procedures

150
Changing modes
6.2 Tubular system - tabletop embroidery
The conversion is not to be carried out when the machine is running.
To convert from tubular system to tabletop embroidery, follow the
same steps as for converting from tabletop embroidery to tubular
system operation, but in the reverse sequence.
6.3 Changing from tubular system to cap embroidery
The conversion is not to be carried out when the machine is running.
The conversion for optional cap embroidery is described in the
operating instructions for the cap attachment.
6.4 Work to be performed after each mode change
Each time you convert the machine for a di󰀨erent mode, change
the pantograph conguration to suit the application (e.g. border
frame embroidery) by way of the control unit.