178
Installing
11. Installing
11.1 Comparing mains voltage
All installation and service work is to be carried out exclusively
by trained experts.
The machine is at zero current only when the mains plug is
pulled out and after a delay of at least 30 seconds.
The supply voltage of the machine is 230V AC (+-15%) 50/60Hz.
Compare the mains voltage stated on the rating plate with the
system voltage available at the machine location. If the values
are not the same, do not start the machine, but contact our
customer service department.
11.2 Mains connection
The machine is supplied with power cable and plug and may only be operated at
a plug connector with a correctly connected grounding conductor, which has been
setup according to the valid regulations. Compliance with applicable regulations
and, in particular protective measures against electric shocks according to IEC
364/VDE 0100 or corresponding national and local safety regulations must be
observed.
On completion of the installation work, run the connecting
cable between the embroidery machine and mains socket-outlet
in such a way that it is not an obstacle to foot trac (risk of
tripping).
Do not connect the machine to the power supply until it is fully
assembled and the control cabinet is closed.
To Next Page
Loading...
