166
Safety guidelines
8.8 Cleaning and maintenance
Insofar as they are described in the operator’s guide, cleaning and maintenance
tasks must be carried out only by appropriately instructed personnel.
More extensive maintenance and repair tasks must always be carried out by
service personnel that has been trained and accordingly equipped by ZSK
Stickmaschinen GmbH because this work requires the application of special
knowledge and resources.
Always disconnect the power supply before carrying out cleaning and
maintenance work.
The machine is at zero current only when the mains plug is pulled out and after a
delay of at least 30 seconds.
Observe the regular servicing periods laid down in the operator’s guide.
8.9 Repairs and modications
Repair and modication work must be carried out only by service personnel
that has been instructed and trained by ZSK Stickmaschinen GmbH. Note the
following:
Use only genuine spare parts and accessories or parts that have been approved by
ZSK Stickmaschinen GmbH.
The machine must not be started up until it is fully assembled with all safety
covers and devices installed.
Independent changes and modications to the machine are not permitted for
safety reasons and may conict with CE regulations.
Modication work does not include the conversion tasks described in the
operator’s guide (e.g. deinstallation/reinstallation of the sequin device).
To Next Page
Loading...
