151
Preparing to embroider
7. Preparing to embroider
As a general rule, carry out the work described here only when
the machine is stationary. Make sure that no-one is able to start
the machine while you are tting the embroidery material and
setting it up.
This chapter describes additional work that has to be executed
before embroidering. Further information, including on the choice of
needles, lling the yarn rack, thread tension etc., is contained in the
relevant operator’s guide – head –.
7.1 Clamping embroidery material
7.1.1 Tubular system embroidery
Adjusting frame tension
Adjust the frame tension to match the
thickness of the embroidery material
with the adjusting screw (1) on the
outer frame.
Abb. 40: Tubular system embroidery, screw for adjusting frame tension
To Next Page
Loading...
