ZSK JAFA - Changing from Tubular System to Border Frame Embroidery; Changing from Tubular System to Cap Embroidery

195
Changing modes
13.5 Changing from tubular system to border frame
embroidery
The conversion is not to be carried out when the machine is running.
When you wish to embroider in the border frame mode, it is
essential that you return the work table support to the top
position, otherwise the work tables can break.
To convert from tubular system to border frame embroidery, follow
the same steps as for converting from border frame to tubular
system operation, but in the reverse sequence.
Each time you convert the machine for a di󰀨erent mode, change the
pantograph conguration to suit the application (e.g. border frame
embroidery) by way of the control unit.
13.6 Changing from tubular system to cap embroidery
The conversion for optional cap embroidery is described in the
operating instructions for the cap attachment.
Each time you convert the machine for a di󰀨erent mode, change the
pantograph conguration to suit the application (e.g. border frame
embroidery) by way of the control unit.