100/782
With just two branch offices, you could just manually set up VPN tunnels between
HQ and the branches. With many branches it's best to use the VPN Concentrator
to set up branch-HQ tunnels automatically.
ZyWALL/USG Hub-and-Spoke VPN Example
Set Up the IPSec VPN Tunnel on the ZyWALL/USG by Using VPN
Concentrator Hub_HQ-to-Branch_A
In the ZyWALL/USG, go to Quick Setup > VPN Setup Wizard, use the VPN Settings
wizard to create a VPN rule that can be used with the remote ZyWALL/USG. Click
Next.
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This example
was tested using USG310 (Firmware Version: ZLD 4.25).
To Next Page
Loading...
