752/782
Make sure that passive device (Device 2) sync process
successfully
it starts to Device-HA Sync process. You can use CLI on passive device to
check sync status. When it has done, you can see status indicated that
"Device HA Sync has succeeded from X.X.X.X at YYYY-MM-DD HH:MM:SS"
Router> show device-ha2 sync status
Note: There are 2 ways to force device sync configurations itself. It can start
process from different role.
On Passive device: Router# device-ha2 sync_from_active
On Active device: Router# device-ha2 sync_to_passive
On Passive device: Router> debug device-ha2 passive sync now
To Next Page
Loading...
