269/782
How to Configure L2TP VPN with iOS 8.4 Mobile Devices
This example shows how to use the VPN Setup Wizard to create a L2TP VPN
between a ZyWALL/USG and an iOS 8.4 Mobile Device. The example instructs how
to configure the VPN tunnel between each site. When the VPN tunnel is
configured, each site can be accessed securely and allow traffic from L2TP
clients to go to the Internet.
ZyWALL/USG L2TP VPN with iOS Mobile Devices Example
Set Up the L2TP VPN Tunnel on the ZyWALL/USG
In the ZyWALL/USG, go to Quick Setup > VPN Setup Wizard, use the VPN Settings
for L2TP VPN Settings wizard to create a L2TP VPN rule that can be used with the
remote iOS Mobile Devices. Click Next.
Quick Setup > VPN Setup Wizard > Welcome
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This example
was tested using USG310 (Firmware Version: 4.25) and iOS (Firmware Version: 8.4).
To Next Page
Loading...
