610/782
Apply the Configuration Files on the ZyWALL/USG
In the ZyWALL/USG, go to MAINTENANCE > File Manager > Configuration File,
select a specific configuration file to have ZyWALL/USG use it. For example, select
the system-default.conf file and click Apply to reset all of the ZyWALL/USG settings
to the factory defaults. Or select the lastgood.conf which is the most recently
used (valid) configuration file that was saved when the device last restarted. If
you uploaded and applied a configuration file with an error, select this file then
click Apply to return to a valid configuration.
MAINTENANCE > File Manager > Configuration File
A pop-up screen will appear allowing you to edit the Target file name. Select
Immediately stop applying the configuration file and roll back to the previous
configuration to get the ZyWALL/USG started with a fully valid configuration file as
quickly as possible. Click OK to have the ZyWALL/USG start applying the
configuration file.
MAINTENANCE > File Manager > Configuration File > Apply Configuration File
To Next Page
Loading...
