ZyXEL Communications ZyWall ATP series - How to Configure Site-To-Site Ipsec VPN with a Sonicwall Router

212/782
www.zyxel.com
How to Configure Site-to-site IPSec VPN with a SonicWALL
router
This example shows how to use the VPN Setup Wizard to create a site-to-site VPN
between a ZYWALL/USG and a SonicWALL router. The example instructs how to
configure the VPN tunnel between each site. When the VPN tunnel is configured,
each site can be accessed securely.
ZyWALL/USG Site-to-site IPSec VPN with SonicWALL
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This example
was tested using USG310 (Firmware Version: ZLD 4.25) and NSA240 (Firmware Version:
SonicOS Enhanced 5.8.0.1-31o)