244/782
How to Configure L2TP over IPSec VPN while the ZyWALL/USG
is behind a NAT router
This example shows how to use the VPN Setup Wizard to create a L2TP over
IPSec VPN tunnel between ZyWALL/USG devices. The example instructs how to
configure the VPN tunnel between each site while the ZyWALL/USG is behind a
NAT router. When the L2TP over IPSec VPN tunnel is configured, each site can
be accessed securely.
ZyWALL/USG L2TP over IPSec VPN while the ZyWALL/USG is behind a NAT router
Note:
All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks.
This example was tested using USG110 (Firmware Version: ZLD 4.25).
To Next Page
Loading...
