ZyXEL Communications ZyWall ATP series - Set up the USB System Settings

451/782
www.zyxel.com
ZyWALL/USG enable and send logs to the USB storage
Set Up the USB System Settings
Go to CONFIGURATION > System > USB Storage > Settings > General. Select Activate
USB storage service if you want to use the connected USB device(s).
Set a number and select a unit (MB or %) to have the ZyWALL/USG send a warning
message when the remaining USB storage space is less than the value you set here.
CONFIGURATION > System > USB Storage > Settings > General
Note: Only connect one USB device. It must allow writing (it cannot be read-
only) and use the FAT16, FAT32, EXT2, or EXT3 file system. This example was tested
using USG110 (Firmware Version: ZLD 4.25).