240/782
If the Security Policy is created but still cannot access to ZyWALL, please go to
CONFIGURAITON > System > SSH to check do you Enable the General Settings
and make sure the Service Port is correct and the same in your terminal program.
Then, check the Service Control Action should be Accept.
CONFIGURAITON > System > SSH
Enter the command line in terminal mode (Using Tera Term in this example).
Tera Term command
Test the IPSec VPN Tunnel
8 Go to ZYWALL/USG CONFIGURATION > VPN > IPSec VPN > VPN Connection, click
Connect on the upper bar. The Status connect icon is lit when the interface is
connected.
CONFIGURATION > VPN > IPSec VPN > VPN Connection
To Next Page
Loading...
