745/782
Reboot passive device(Device 1) by standby partition
Device 2- Reboot device by standby partition
Access device by Device-HA management IP address.
Go to Maintenance > File Manager > Firmware Management.
Select standby partition, and click Reboot button.
After device boots up successfully, the device 2 role will stay as Passive.
All of traffic will pass by Active device continually.
Reboot active device(Device 1) by standby partition
Device 1- Reboot device by standby partition
Go to Maintenance > File Manager > Firmware Management.
Select standby partition, and click Reboot button.
After device boots up successfully, device 2 role will become to “Active”.
All traffic will handle by Active device (device 2).
Note: Since partitions have their own startup-config.conf. So reboot device by different
partitions will not overwrite configuration again. In this example, partition#1 already exist
4.33 configuration. So there is no configuration need to changed.
To Next Page
Loading...
