ZyXEL Communications ZyWall ATP series - Spoke_Branch_B

153/782
www.zyxel.com
Go to Network > Routing > Policy Route to add a Policy Route to allow traffic from
Spoke_Branch_A to Spoke_Branch_B.
Click Create new Object and set the address to be the local network behind the
Spoke_Branch_B. Select Source Address to be the local network behind the
Spoke_Branch_A. Then, scroll down the Destination Address list to choose the
newly created Spoke_Branch_B_LOCAL address. Click OK.
Network > Routing > Policy Route
Spoke_Branch_B
Go to CONFIGURATION > VPN > IPSec VPN > VPN Gateway, select Enable. Type
the VPN Gateway Name used to identify this VPN gateway.
Then, configure the Primary Gateway IP as the Hub_HQ’s wan1 IP address (in the
example, 172.16.10.1) and Secondary Gateway IP as the Hub_HQ’s wan2 IP