61/782
Go to ZyWALL/USG MONITOR > VPN Monitor > IPSec and verify the tunnel Up
Time and Inbound (Bytes)/Outbound (Bytes) Traffic.
MONITOR > VPN Monitor > IPSec
What Could Go Wrong?
If you see below [info] or [error] log message, please check ZyWALL/USG Phase
1 Settings. Make sure your ZyWALL/USG Phase 1 Settings are supported in the
Amazon VPC IKE Phase 1 setup list.
MONITOR > Log
If you see that Phase 1 IKE SA process done but still get below [info] log
message, please check ZyWALL/USG Phase 2 Settings. Make sure your
ZyWALL/USG Phase 2 Settings are supported in the Amazon VPC IKE Phase 2
setup list.
MONITOR > Log
To Next Page
Loading...
