ZyXEL Communications ZyWall ATP series - Change Partition Flow; Check Firmware Version on Active and Passive Devices

744/782
www.zyxel.com
Change Partition Flow
1. Make sure the running and standby firmware version of active and passive
devices are the same.
2. Reboot passive device(Device 2) by standby partition
3. Reboot active device(Device 1) by standby partition
4. Make sure passive device(Device 1) sync process completed successfully.
5. Configuration changed scenario.
Check Firmware Version on Active and Passive devices
Go to Maintenance > File Manager > Firmware Management.
The running and standby firmware on both of devices must be the same
Active(Device 1)- Running Firmware 4.35(ABIQ.2), Standby Firmware 4.33(ABIQ.1)
Passive(Device 2)- Running Firmware 4.35(ABIQ.2), Standby Firmware 4.33(ABIQ.1)