63/782
How to Configure Site-to-site IPSec VPN Where the Peer has
a Static IP Address
This example shows how to use the VPN Setup Wizard to create a site-to-site VPN
with the Peer has a Static IP Address. The example instructs how to configure the
VPN tunnel between each site. When the VPN tunnel is configured, each site can
be accessed securely.
ZyWALL Site-to-site IPSec VPN with a Static IP Address Peer
Set Up the ZyWALL/USG IPSec VPN Tunnel of Corporate Network (HQ)In the
ZyWALL/USG, go to Quick Setup > VPN Setup Wizard, use the VPN Settings wizard
to create a VPN rule that can be used with the remote ZyWALL/USG. Click Next.
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This example
was tested using USG310 (Firmware Version: ZLD 4.25).
To Next Page
Loading...
