402/782
(SNI) extension fields in server FQDN. Using the SNI to query category from Commtouch
engine, then take action when it matches the block category in Content Filter profile.
ZyWALL/USG Domain Filter Example
Set Up the Content Filter on the ZyWALL/USG
Go to CONFIGURATION > UTM Profile> Content Filter > Profile > General Settings. Select
Enable HTTPS Domain Filter for HTTPS traffic.
Go to CONFIGURATION > UTM Profile> Content Filter > Profile Management > Add Filter
Note: All network IP addresses and subnet masks are used as examples in this
article. Please replace them with your actual network IP addresses and subnet
masks. This example was tested using USG310 (Firmware Version: 4.25)
To Next Page
Loading...
