ZyXEL Communications ZyWall ATP series - Set up the Port Grouping on the Zywall;Usg; Set up the VLAN on the Zywall;Usg

639/782
www.zyxel.com
Set Up the Port Grouping on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Interface > Port Grouping,
select the ports that you want to assign to a representative Interface (in this
example, Port 4 and Port 5 are configured as ge5).
CONFIGURATION > Network > Interface > Port Grouping
Set Up the VLAN on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Interface > VLAN. Set
Interface Type to be External. Set Zone to be WAN, configure Base Port to be ge5.
Enter the VLAN ID and configure the fixed IP address (172.17.1.1/24 in this
example). Click OK to go back to the Configuration page.
CONFIGURATION > Network > Interface > VLAN