ZyXEL Communications ZyWall ATP series - After Received the New Device (Device 3)

738/782
www.zyxel.com
Go to Configuration>Licensing>Registration>Service>Press Service License Refresh
After received the New device (Device 3)
1. Backup the Device 1 current configuration.
2. Make sure the Device 3 is reset to default setting
3. On Device 3, the running firmware version must the same as the Device 1.
4. On Device 3, the partition of running firmware must be the same position as the Device 1.
Active (Device 1)- Running Firmware 4.35(ABIQ.2)
Passive (Device 3)- Running Firmware 4.35(ABIQ.2)
Note: If RMA device which was initial active role (S/N was filled on HA-PRO page),
user needs to modify the S/N to another Device (On Serial Number of Licensed Device
for License Synchronization)