461/782
1. Navigate to IPv6 Router Advertisement Setting, enable Router Advertisement, it would advertise
the prefix to the Lan host, also enable Adviertised Hosts Get Other Configuration From DHCPv6,
Lan hosts will get the DNS address from USG.
2. Configure Advertised Prefix from DHCPv6 Prefix Delegation, the Lan hosts will get the Prefix from
USG, Suffix address can set 0～F
Test
1. Connect a computer to the ZyWALL’s LAN interface.
2. Enable IPv6 support on you computer.
In Windows XP, you need to use the IPv6 install command in a Command
Prompt.
In Windows 7, IPv6 is supported by default. You can enable IPv6 in the Control
Panel > Network and Sharing Center > Local Area Connection screen.
3. Your computer should get an IPv6 IP address (starting with 2001:b050:2d:1111: for
this example) from the ZyWALL.
To Next Page
Loading...
