ZyXEL Communications ZyWall ATP series - Page 392

392/782
www.zyxel.com
CONFIGURATION > Network > Interface > VTI > vti1 > Connectivity Check
6 In the same screen, create a VTI for the VPN tunnel BO2. Be aware that
the IP address of this VTI must be in the same subnet as vti2 on USG1. In this example,
the IP address and subnet mask of vti2 on USG1 is 10.10.11.10 and 255.255.255.0
respectively. The IP address of vti2 on USG2 must be in the subnet of 10.10.11.0/24.
Enable the connectivity check. Enter the IP address of vti2, which is configured on
USG1.
CONFIGURATION > Network > Interface > VTI > Add