ZyXEL Communications ZyWall ATP series - Page 446

446/782
www.zyxel.com
5. Enter the port number you want Vantage Report to use for web services. Make sure
this port number does not conflict with the other services in your network. Click
Next.
6. Check if any applications also use port 3316 (TCP), 514 (UDP) or 8080 (UDP) by
entering “netstat -a” into the command line. Uninstall them if any. Click OK.
When you finish installing Vantage Report, restart the Vantage Report server.
7. Open the browser window and go to http://a.b.c.d:xxxxxx/vrpt, where a.b.c.d is
the IP address of the Vantage Report server. If you open the configurator on the
same computer on which you installed Vantage Report server, enter localhost.