747/782
(1) Access to device FTP server by admin & password to download
configurations.
A. Download running(4.33) partition configuration.
Go to “/conf” folder and download startup-config.conf
B. Download standby(4.35) partition configuration.
Go to “/standby_conf” folder and download startup-config.conf
(2) Open both of configuration by text and use any compare tool to
check what difference between your configurations. And then try to add
configuration by CLI command. (e.g. https://text-compare.com/)
(3) In some of scenario device will reply “% Command not found” to you
since system doesn’t support such command. You can ignore following
items:
a. Local Users
User password uses different hashing algorithms, so password will be
different.
b. New Feature Enhancement
New feature only works in new firmware. So use CLI command to enter
them will be fail. (e.g. IP reputation)
To Next Page
Loading...
