ABB ACS180 - Page 279

Parameters 279
Reset end user texts Restores all end user texts to default values, including the
drive name, contact info, customized fault and warning
texts and currency unit.
If the value of parameter 40.79 is set to User Text, then
the PID unit is also reset. If parameter 40.79 has some
other value, the PID unit cannot be reset.
1024
Reset motor data Restores all motor nominal values and motor ID run
results to default values.
2
All to factory defaults Restores settings and all editable parameters back to
initial factory values, except
the differentiated defaults implemented by parameter
95.20.
34560
96.07 Parameter save
manually
Saves the valid parameter values to the permanent
memory on the drive control board to ensure that
operation can continue after cycling the power. Save the
parameters with this parameter
• to store values sent from the fieldbus
• when using external +24 V DC power supply to the
control unit: to save parameter changes before you
power down the control unit. The supply has a very
short hold-up time when powered off.
Note: A new parameter value is saved automatically
when changed from the PC tool or control panel but not
when altered through a fieldbus adapter connection.
Done
Done Save completed. 0
Save Save in progress. 1
96.08 Control board boot Changing the value of this parameter to 1 reboots the
control unit (without requiring a power off/on cycle of the
complete drive module).
The value reverts to 0 automatically.
0
0 No action 1 = 1
1 Reboot the control unit.
96.10 User set status Shows the status of the user parameter sets.
This parameter is read-only.
See also section User parameter sets (page 97).
-
n/a No user parameter sets have been saved. 0
Loading A user set is being loaded. 1
Saving A user set is being saved. 2
Faulted Invalid or empty parameter set. 3
User1 IO active User set 1 has been selected by parameters 96.12 User
set I/O mode in1 and 96.13 User set I/O mode in2.
4
User2 IO active User set 2 has been selected by parameters 96.12 User
set I/O mode in1 and 96.13 User set I/O mode in2.
5
User3 IO active User set 3 has been selected by parameters 96.12 User
set I/O mode in1 and 96.13 User set I/O mode in2.
6
User4 IO active User set 4 has been selected by parameters 96.12 User
set I/O mode in1 and 96.13 User set I/O mode in2.
7
User1 backup User set 1 has been saved or loaded. 20
User2 backup User set 2 has been saved or loaded. 21
No. Name/Value Description Default
FbEq 16
ACS180 FW.book Page 279 Tuesday, March 9, 2021 2:25 PM